Overview
3
3 Overview
The
TP-575
is a twisted pair line driver and DA for HDMI. The
TP-575
receives an HDMI signal from a transmitter (for example, the Kramer
PT-571
)
via the LINE IN RJ-45 connector. It decodes this input signal to the local output
and simultaneously transmits it to a TP receiver (for example, the
PT-572+
)
which converts it back to an HDMI signal
1
Using the
TP-575
, you can pass via the twisted pair cable:
.
•
EDID (Extended Display Information Data) and HDCP signals
•
HPD (Hot Plug Detect) signals from the display device to the source
The
TP-575
features:
•
Up to 1.65Gbps bandwidth per graphic channel
2
•
HDTV compatibility
•
A system range
3
Use only shielded cables with the
TP-575
in which the cable Ground shielding
must be connected / soldered to the shield of both RJ-45 connectors
of up to 90m (295ft) at 1080i, or up to 30m (98ft) at
1080p on shielded
BC-DGKat524
cable; 90m (295ft) at 1080i, or up to
70m (230ft) at 1080p on shielded
BC-DGKat623
cable; 100m (330ft) at
1080i or up to 90m (295ft) at 1080p on shielded
BC-DGKat7a23
cable.
•
HDMI Support – HDMI (V.1.4 with Deep Color, x.v.Color™, HDMI
Uncompressed Audio Channels, Dolby TrueHD, DTS-HD)
•
Output signal reclocking, letting you daisy chain up to six receivers
•
3D Pass-Through
•
The Power Connect System™ – A single connection to the
TP-575
powers the transmitter, receiver and line driver units
•
The ability to read and store, in non-volatile memory, the default
EDID, or the EDID
4
•
LEDs that indicate the selected input as well as the active output LED
indication
block from either or both of the output display
devices, so it can then provide the EDID information to the HDMI
sources even if the display device is not connected
1 The Kramer PT-571 and PT-572+ user manual is available on our Web site at
http://www.kramerelectronics.com
2 Suitable for resolutions up to UXGA at 60Hz, and for all HD resolutions
3 Note that the transmission range depends on the signal resolution, graphics card and display used. The distance using non-
Kramer CAT 5, CAT 6 and CAT 7a cables may not reach these ranges
4 EDID is Extended Display Identification Data (see section
3.2
for a more detailed definition)
