#
Feature
Function
10
LAN MEDIA 1G(PoE) RJ-45
Port
Connect for streaming either directly to a decoder or via LAN.
•
Dante:
When connected to Dante audio via the network, provides 2 Tx channels and
2 Rx channels. By default, DHCP is enabled on Dante.
•
PoE: KDS-SW3-EN7
is powered by PoE (power over ethernet) delivered through the
LAN MEDIA port, unless the optional 24V DC connector is attached.
•
Multicast:
Connect to multiple decoders or connect to one decoder to which multiple
decoders are daisy-chained via the SERVICE (1G) port.
11
LAN SERVICE 1G RJ-45 Port
Used optionally for physical separation between AV and command streams to separate
LAN for security and reliability purposes.
12
RS-232 3-pin Terminal Block
Connector
Connect to an RS-232 device to use as a Gateway and bi-directional signal extension
(even when no AV signal is extended).
13
AUDIO IN/OUT 5-pin Terminal
Block Connector
Connect to a balanced analog stereo audio source/acceptor.
14
IR 3.5 Mini Jack
Connect to an IR sensor or emitter for bi-directional signal extension (even when no AV
signal is extended). Expected voltage for IR receiver - (3.3V).
15
USB Type A Ports (1 and 2)
Connect to USB devices, for example, to a speakerphone and webcam.
16
HOST USB Type B Port
Connect to a USB host.
17
HDMI OUT Connector
Connect to loop the signal.
LED Functionality
KDS-SW3-EN7
LEDs function as follows:
LED
Color
Definition
LINK LED
Lights Green
A link is established between
KDS-SW3-EN7
and the decoder is
transmitting A/V signals.
Flashes Green
A signal is established, and a problem is detected.
NET LED
Off
No IP address is acquired.
Lights Green
A valid IP address has been acquired.
Flashes Green very fast (for 60sec)
A device identification command is sent (Flag me).
Lights Yellow
No DHCP IP was assigned, so the device is using the fallback (default) IP
address, 192.168.1.39.
ON LED
Flashes Red
The default IP address is unavailable, and the device is acquiring a fallback
IP address in subnet 192.168.0.0/16.
The ON LED flashes continuously in a slow 0.5/10sec cadence.
Lights Green
When power is on.
Flashes Green fast
FW is downloaded in the background.
Flashes Green very fast (for 60sec)
A device identification command is sent (Flag me).
Lights Yellow
Device falls back to the default IP address.
Post reboot, all LEDs light for 3 seconds then return to their normal LED display mode.
Step 3: Mount KDS-SW3-EN7
Install
KDS-SW3-EN7
using one of the following methods:
•
Attach the rubber feet and place the unit on a flat surface.
•
Fasten a bracket (included) on each side of the unit and attach it to a flat surface
www.kramerav.com/downloads/KDS-SW3-EN7
•
Mount the unit in a rack using the recommended rack adapter
www.kramerav.com/product/KDS-SW3-EN7
•
Ensure that the environment (e.g., maximum ambient
temperature & air flow) is compatible for the device.
•
Avoid uneven mechanical loading.
•
Appropriate consideration of equipment nameplate ratings
should be used for avoiding overloading of the circuits.
•
Reliable earthing of rack-mounted equipment should be
maintained.
•
Maximum mounting height for the device is 2 meters.