Kramer FC-4001, Руководство пользователя

Страница: 6 / 15

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your FC-4001 Format Converter / TBC
4
Table 1: Front Panel FC-4001 Format Converter / TBC
# Feature Function
1 POWER Switch Illuminated switch for turning the unit ON or OFF
2 FINE Trimmer
3
S
Y
N
C
P
H
A
S
E
COARSE Trimmer
Adjusts
1
the sync phase level
4 FINE Trimmer
5
S
C
H
COARSE Trimmer
Adjusts
1
the horizontal-to-subcarrier phase level
6 Y/C Button Selects the s-Video source for conversion
2
7 CV Button Selects the composite video source for conversion
2
8 SDI Button Selects the serial digital video source for conversion
2
9 RGB/S Button Selects the RGB/S source for conversion
2
10
IN
P
U
T
S
E
LE
C
TO
R
YUV Button Selects the YUV source for conversion
2
11 LOCK Button
3
Disengages the front panel buttons
12 FREEZE Button Freezes the output video
13 GENLOCK Button Press to enable GENLOCK operation
Table 2: Rear Panel FC-4001 Format Converter / TBC
# Feature Function
14 LOOP BNC Connector Connects to the next Genlocked unit
15 SYNC BNC Connector Connects to the Genlock source
16 Term Button
Press to terminate the Genlock source (75 ) or release for
looping
4
17 CV BNC Connector Connects to the composite video source
18 Y/C 4p Connector Connects to the s-Video (Y/C) source
19 G/Y BNC Connector
20 R/R-Y BNC Connector
21 B/B-Y BNC Connector
22 SYNC BNC Connector
Connects to the RGB (connect all 3 connectors: R /R-Y, G /Y,
and B /B-Y),
or YUV (connect all 3 connectors: R/ R-Y , G/ Y , and B/ B-Y ),
or RGBS (connect all 4 connectors:
R
/R-Y,
G
/Y, and
B
/B-Y,
and
SYNC
)
video source
23
IN
P
U
TS
SDI BNC Connector Connects to the SDI source
24 SDI BNC Connector Connects to the serial digital video acceptor 1
25 SDI BNC Connector Connects to the serial digital video acceptor 2
26 CV/R/R-Y BNC Connector
27 G/Y BNC Connector
28 SYNC BNC Connector
29
O
U
TP
U
TS
C/B/B-Y BNC Connector
Connects to the RGB (connect all 3 connectors: CV/ R /R-Y,
G /Y, and C/ B /B-Y),
or YUV (connect all 3 connectors: CV/R/ R-Y , G/ Y , and C/B/ B-Y ),
or RGBS (connect all 3 connectors: CV/ R /R-Y, G /Y, and C/ B /B-Y,
and SYNC)
video acceptor
30 SETUP Dipswitches Dipswitches setup (see section 6.2)
31 RS-232 Port Connects to the PC or the Remote Controller
32 Power Connector with Fuse AC connector enabling power supply to the unit
1 Insert a screwdriver into the small hole and carefully rotate it, trimming the level
2 In addition, the signal is also converted to two identical SDI outputs
3 Press for about 2 seconds to lock/unlock the panel
4 Push in to terminate the input. Release when the input extends to another unit