Kramer FC-21ETH, Руководство пользователя

Страница: 21 / 60

Connecting the FC-21ETH, FC-22ETH and FC-24ETH 17
6.1 Connecting via Ethernet
You can connect to the FC-24ETH via Ethernet using either of the following
methods:

Directly to the PC using a crossover cable (see Section
‎6.1.1
)

Via a network hub, switch, or router, using a straight-through cable (see
Section
‎6.1.2
)
Note : If you want to connect via a router and your IT system is based on IPv6,
speak to your IT department for specific installation instructions.
6.1.1 Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the FC-24ETH directly to the Ethernet port on
your PC using a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the FC-24ETH
with the factory configured default IP address.
After connecting the FC-24ETH to the Ethernet port, configure your PC as follows:
1. Click Start > Control Panel > Network and Sharing Center .
2. Click Change Adapter Settings .
3. Highlight the network adapter you want to use to connect to the device and
click Change settings of this connection .
The Local Area Connection Properties window for the selected network
adapter appears as shown in Figure 10 .
i