CRS-AOCH/CLR/60 Plug and Play Installation
Before installing the cable, make sure that you have an HDMI graphic card or devices with an HDMI
port (for example, a PC, laptop, DVD/Blue-ray player or any other video/audio signal source devices).
Kramer
CRS-AOCH/CLR/60
Fiber Optic HDMI cables are designed to take
+5V DC power from the source devices to the HDMI pin #18 of the SOURCE
side connector on the cable.
Optical fiber cable is not robust physically compared to conventional copper
cable materials. Even if this cable is designed to be seamlessly resistant at
certain levels of artificial strengths to the cable,
CRS-AOCH/CLR/60
can be
damaged if it is excessively pinched, twisted or kinked when being installed
and after being installed.
Be careful not to bend or twist the cable tightly
.
When
CRS-AOCH/CLR/60
is installed into the conduit, the fiber pulling
strength and the bending radius are the key conditions to safe installation of
the cable:
Maximum fiber bending radius
: 90mm
Maximum fiber pulling/tensile strength
: 50kg (500N)
Crush Resistance
: 50kg (500N)
Do not disassemble or modify the products, especially the HDMI connector
head parts. Do not remove the dust plug before the cable laying process is
completed. HDMI connector heads are very critical parts. Remove the head at
the last moment just before the connector is plugged into the source or the
display devices after the installation is complete.
To install the
CRS-AOCH/CLR/60:
1. Unpack the cable from the package with care and remove the cable tie.
We recommend that you save the original box and packaging materials for possible future
shipment.
2. Install the cable (for example, an in-wall or conduit installation or under-floor installations).
3. Once the cable installation is complete, remove the dust cap and plug the SOURCE
green
connector head of the cable into the source devices.
Do not plug the SOURCE
green
connector to the display device
.
4. Remove the dust cap and plug the DISPLAY
red
connector head of the cable into the display
devices.
Do not plug the DISPLAY
red
connector to the source device
.
5. Switch on the power of source and display devices.
