908 - 908 Commands in Protocol 3000
27
Command chain separator character
When a message string contains more then one command, a pipe ( '|' ) character
separates each command.
Spaces between parameters or command terms are ignored.
9.10.7
Entering Commands
You can directly enter all commands using a terminal with ASCII communications
software, such as HyperTerminal, Hercules, etc. Connect the terminal to the serial,
Ethernet, or USB port on the Kramer device. To enter
CR
, press the Enter key.
(
LF
is also sent but is ignored by command parser).
For commands sent from some non-Kramer controllers like Crestron, some
characters require special coding (such as, /X##). Refer to the controller manual.
9.10.8
Command Forms
Some commands have short name syntax in addition to long name syntax to allow
faster typing. The response is always in long syntax.
9.10.9
Command Chaining
Multiple commands can be chained in the same string. Each command is
delimited by a pipe character ( '|' ). When chaining commands, enter the
message
starting character
and the
message closing character
only once, at the
beginning of the string and at the end.
Commands in the string do not execute until the closing character is entered.
A separate response is sent for every command in the chain.
9.10.10 Maximum String Length
64 characters.
Содержание 908
Страница 2: ......
Страница 31: ...28 908 908 Commands in Protocol 3000 ...