To install/replace the
OSP-MM1
or other Kramer recommended SFP+
transceiver
:
1. Pull the bail out and remove the currently installed transceiver,
insert the protective cap and store in a safe place.
2. Make sure the bail of the new transceiver is pushed up, in the
closed position.
3. Insert the new transceiver into the relevant optical device SFP+ slot
and push it in until it clicks.
4. Remove the protective cap and store it in a safe place for future
use.
Warning:
Connecting the SFP+ transceiver to an LC(APC) fiber
connector may cause poor performance and damage the connector!
Refer to
www.kramerav.com/downloads/OSP-MM1
Warning: Class 1 Laser Product
•
Invisible laser radiation present.
•
Avoid long-term viewing of laser.
•
Avoid the use of magnifying viewing aids or instruments (such as binoculars, telescopes, microscopes and
magnifying lenses, but not spectacles or contact lenses).
•
Avoid placing optical devices in the emitted beam that could cause the concentration of the laser radiation to be
increased.
Step 5: Connect the power
Connect the power cords to
675T
and
675R
and plug into the mains electricity.
Safety Instructions (See
for updated safety information).
Caution:
•
There are no operator serviceable parts inside the unit.
Warning:
•
Use only the power cord that is supplied with the unit.
•
Disconnect the power and unplug the unit from the wall before installing.
