KRAFTWERK 32108, Инструкция по использованию

Страница: 9 / 12

9
to drill or screw. The LED lamp (10) will be lit
automatically as soon as you press the ON/OFF
switch (4).
8.9 Changing the tool (Fig. 9)
Important. Set the changeover switch (3) to its
centre position whenever you carry out any work
(for example changing the tool, maintenance
work, etc.) on the cordless screwdriver.
• The cordless screwdriver is fitted with a
quickaction chuck (9) with an automatic spindle
stop.
• Open the chuck (9). The chuck opening (a) must
be large enough to hold the tool (drill bit or
screwdriver bit).
• Select the suitable tool. Push the tool as far as
possible into the chuck opening (a).
• Tighten the chuck (9) and then check that the
tool is secure.
8.10 Screwdriving
We recommend using self-centering screws (e.g.
Torx screws, recessed head screws) designed for
reliable working. Be sure to use a bit that matches
the screw in shape and size. Set the torque, as
described elsewhere in these operating
instructions, to suit the size of screw.
9. Technical data
Voltage supply: 18 V d.c. / 2.0 Ah Li-Ion
Idling speed: 0-400/0-1400 rpm
Torque settings: 19+1
Max. torque: 45 Nm
Forward and reverse rotation: yes
Chuck clamping width: 2-13 mm
Battery charging voltage: 21 V d.c.
Battery charging current: 2200 mA
Mains voltage for charger: 220-240 V~/50-60 Hz
Charging time: 1 h
Weight: 1.74 kg
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
LpA: sound pressure level 71.5 dB(A)
KpA: uncertainty 3 dB
LWA: sound power level 82.5 dB(A)
KWA: uncertainty 3 dB
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three
directions) determined in accordance with EN
60745.
Drilling in metal
Vibration emission value ah = 3.8 m/s
2
K uncertainty = 1.5 m/s
2
Screwing without hammer action
Vibration emission value ah <2.5 m/s
2
K uncertainty = 1.5 m/s
2
Important!
The vibration value changes according to the area
of application of the electric tool and may exceed
the specified value in exceptional circumstances.
10. Cleaning and maintenance
Always pull out the mains power plug before
starting any cleaning work.
10.1 Cleaning
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
• We recommend that you clean the device
immediately each time you have finished using it.
• Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the plastic
parts of the equipment. Ensure that no water can
seep into the device.
10.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.