KRAFT KF-HS125W, Руководство пользователя

Страница: 26 / 36

26
ВЕРТИКАЛЬНАЯ МОРОЗИЛЬНАЯ КАМЕРА
UPRIGHT FREEZER
ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИИ • USER GUIDE
INSTALLATION AND CONNECTION
SPACE REQUIREMENTS
• The freezer is not built-in. There should be a free space of at least 10 cm on the back
and sides, and at least 30 cm on the top to allow air circulation and reduce energy
consumption. Well ventilate the room in which the freezer is located.
• Make sure that the appliance is in a stable position and is installed on a solid and
level floor.
• Do not install the freezer near heat sources, direct sunlight, or high humidity.
• Make sure that the voltage of the electric current specified in the instructions
corresponds to the parameters of your power supply. Do not use adapters, extension
cords, or «T-pieces» to connect the appliance.
• If necessary, replace the power cord, make sure that it
meets the applicable standards and meets the product
specifications.
• When installing the freezer with the side facing the wall of
the room, ensure that there is sufficient space to open the
door at an angle of more than 90 degrees to allow for free
removal of the drawers.
• To avoid vibration, check the level of the freezer unit. If
necessary, adjust the height of the legs to compensate for
the uneven floor by tilting the freezer slightly and turning the
legs clockwise (to lower) and counterclockwise (to raise).
To make the door close better, the freezer should be slightly
tilted back.
• Before use, wash the freezer thoroughly with a soda solution and wipe dry with a soft
cloth. Install the removable drawers in the appropriate places.
THE CONDITIONS OF ACCOMMODATION
Install the appliance in a room where the ambient temperature corresponds to the
label on the climate class of the freezer.
GROUNDING
This appliance is equipped with a grounded plug installed on the power cord.
Therefore, it must be connected to an appropriate electrical outlet to protect against
short circuits.
Installation
screw
Install door handle
Rear spacer
Screw the rear spacers at the rear of the unit.
xxxmm
xxxmm
Space Requirement

Keep enough space of door open.

Keep at least 50mm gap at two sides.
To do this adjust the two levelling feet at front of the unit.
If the unit is not level, the doors and magnetic seal
alignments will not be covered properly.
Levelling the unit
9
Climate class Ambient temperature
N Subnormal +10°C to +32°C
SN Normal +16°C to +32°C
ST Subtropical +16°C to +38°C
T Tropical +16°C to +43°C