2
REPLACING LIGHT BULBS
T
here is one (1) 40W Type B-10 light bulb located
under the logset bed. Remove the twelve (12)
screws on the cover located on the back of the
fireplace and then remove the rear cover of the
unit.
To remove bulb: Hold socket and pull the old
bulb out.
To replace bulb: Hold socket and push in the
new bulb.
Close the rear cover and secure with the
twelve (12) screws.
Plug in the unit.
MAINTENANCE OF MOTORS
The motors used on both blower fan and
flame simulator assembly are prelubricated
for the extended warranty of the motor, no
further lubrication is required. However,
periodic cleaning/vacuuming of the fan/heater
unit is recommended.
CAUTION: Even though the glass is safety glass it
may break if bumped, struck or dropped. Care
must be taken when handling the glass.
GLASS INFORMATION
1. Under no circumstances should this
product be operated with missing or broken
glass.
2. Do not strike or slam the glass.
3. Do not use abrasive cleaners to clean the
glass.
CLEANING
To clean the unit, first turn off controls on unit
and unplug unit from power source.
To clean the glass door: remove dust with
clean dry cloth or to remove finger prints and
other marks clean glass with clean damp
cloth. Do not use abrasive cleaners or spray
liquids on glass door surfaces.
Metal and metal painted parts should be
cleaned with clean damp cloth only. Do not
use abrasive cleaners or spray liquids on this
surface.
6
WARNING: Disconnect power
before attempting any
maintenance or cleaning to
reduce the risk of fire,
electrical shock or personal
injury.
SERVICE INSTRUCTIONS
WARNING: Do not exceed
40 Watts per light bulb.
Use of a higher rated bulb
may result in a fire
causing property damage
and personal injury.
CAUTION: Wait until the
unit has completely cooled
before attempting any
cleaning.
CAUTION: The bulb in your
unit can become extremely
hot. Allow at least 15 minutes
between turning off the unit
and removing the light bulb to
avoid hot bulb coming in
contact with the skin.
