Kostal INVEOR M, Руководство по эксплуатации, Страница: 28 / 51

Acces s ing data v ia PRO F I BUS
Operating manual for PROFIBUS fieldbus | DOC01185928-0008 | 2016-12 | V1.8 DE 27
The first two process variables (status word and actual frequency) cannot be parameterised and are
always sent. The remaining 8 process variables can be configured using parameters 6.080 to
6.087 .
The "Process data Out" available can be found in chapter 4.1.3 "Process data Out".
Use INVEORpc, MMI or PROFIBUS master for parameterisation.
The structure of the "Process data Out" set in the factory is shown in the following table.
IMPORTANT INFORMATION
Changes to the "device-specific information file (GSD file)" may cause communication
problems.
Frame
No.
Address
Data
type
Designation Unit Description
1 0x0000 WORD* Status word - cannot be parameterised
2 0x0004 REAL*** Actual frequency Hz cannot be parameterised
3 0x0008 REAL
Process data Out 3
(Motor voltage)
V
can be parameterised using
INVEORpc tool
(parameter 6.080)
4 0x000C REAL
Process data Out 4
(Motor current)
A
can be parameterised using
INVEORpc tool
(parameter 6.081)
5 0x0010 REAL
Process data Out 5
(Grid voltage)
V
can be parameterised using
INVEORpc tool
(parameter 6.082)
6 0x0014 REAL
Process data Out 6
(Target frequency value)
Hz
can be parameterised using
INVEORpc tool
(parameter 6.083)
7 0x0018 DWORD**
Process data Out 7
(Digital inputs with bit
coding)
-
can be parameterised using
INVEORpc tool
(parameter 6.084)