
• 3.5 mm to 3.5 mm Stereo Connector Cable (Male to Male)
• 3.5 mm to RCA Connector Cable (Male to Male)
• RCA to RCA Connector Cable (Male to Male)
• Calf Skin Carrying Case
2.
Attach the right and left earcups to the headband assembly by holding in the
headband release button located at the inside of the earcup yoke (see
Figure1). Insert the headband into the earcup yoke (See Figure 2).
3.
Set the E/90 Energizer/Amplifier On/Off switch located on the front panel to
“Off”.
4.
Turn the Acoustic Level Control to the full counterclockwise position.
5.
Connect the custom 5 pin rectangular plug from the stereophone to the input
on the front of the E/90 Energizer/Amplifier marked “Phones”.
6.
FOR HOME USE
Plug the AC adapter into the jack marked “9VDC 1AMP Input” located on the back
panel of E/90 Energizer/Amplifier.
Plug the remaining end of the AC adapter into a “live” wall outlet.
FOR PORTABLE USE
Open Portable Battery Case and insert 6 C-size batteries (Batteries not included)
Close battery case.
Plug the jack connected to the batter case into the input on the back of the E/90
Energizer/Amplifier marked “9VDC Input”.
CONNECTING TO THE SOUND SOURCE
7.
You may connect the E/90 Energizer/Amplifier to your sound source with
either the 3.5 mm to RCA connector cable or RCA to RCA connector cable.
Check your sound source for the connector cable required.
NOTE:
The RCA connectors are located on the back of the E/90
Energizer/Amplifier. When connecting RCA plugs, the red plug is for the righ
channel: the white plug is for the left channel.