KOSMOS MALABARES Lunar, Руководство пользователя

Страница: 10 / 13

www.kosmosmalabares.com Edition Feb. 2012
9
Battery charging
The illuminated product will lose brightness when battery level is low. If the battery reaches a
critical low level, the illuminated product will flash a red light and then it will be turned off by the
battery protection circuitry and can not be turned on until is charged.
You can make a complete battery charge when the brightness is low. The approximate battery
life is specified in the program table for each model.
The batteries can be charged by using any multicharger available in Kosmos Malabares:
 AC adaptor 220V/12VDC - 300mA
 Travel AC auto voltage adaptor 110-240VCA / 12V 500mA
 charge distributor to be used by any 12V source / CAR adaptor
You can also use another standard AC adaptor in case of missing or broken charger, because
the charging regulator has been included inside every illuminated product. This way you just
need to buy an AC adaptor with the following specification:
 Output: 10 to 24VDC (12V recommended) / 300mA
 Connector type: female plug, 2,1mm
 Polarity: (built in reverse polarity protection in every product)
How to charge the batteries?
To charge the battery you should plug any of the charger outputs to the product charging
connector.
If the product is on, it will turn off when receiving charge. This way, it is easy to check the
charging procedure: if the juggling product does not turn off, it means there is some abnormal
behaviour.
The charging time is 14 hours for full charge. It is possible to make partial charges by charging 7
hours, then using the product for a while and then charging again.
Note: charging the product for more than 14 hours will not increase the glowing time. In case
you forget the charger connected to the product for longer time, the protection circuitry will
avoid any overload.
Simultaneous charging of different Kosmos Malabares products connected to the same charger
is allowed.
System reset
Every time the product is charged, a restart occurs. This reset does not clear the program
memory. If for any reason a reset is needed just plug the charger into the AC outlet supply.