ShenZhen Korno Import&Export Co.,Ltd
-20-
To reduce the risk of ignition of hazardous atmospheres, recharge,
remove or replace the battery only in an area known to be
non-hazardous.Do not mix old and new batteries or batteries from
different manufacturers.
Electrostatic discharge should be proceed before the detection in
hazardous area
GT 903 series products shall only be charged outside hazardous
areas,it is strongly recommend use the original charger.
8 Concentration Datalog Output Instruction
GT 903 series gas detector allow user output history datalog via the charge
port,there are several steps to output datalog.
1)Install the corresponding Run Engine(contact with the sales)
2)Set the Language compatibility in the computer, add "Chinese(Simplified,
China)"
3)Install concentration datalog output software in host computer
4)Boot up the detector and wait for 60s to preheat the instrument and
connect to the computer
5)Run the concentration datalog output software in the host computer,make
sure the detector is connected to the host computer,meanwhile at the lower
left interface of the software will show connection port standby(defaulted
baud rate is 115200,do not change)
