Korg PA1X, Руководство пользователя

Страница: 244 / 424

240
Global edit mode
Audio Output: Seq2
Audio Output: Seq2
This page lets you connect Sequencer 2 tracks to the audio out-
puts.
Tracks
Use these parameters to assign an audio output (OUTPUT sec-
tion, on the back of the instrument) to each track.
See “Audio Output: Sty/Kbd” on page 239 for more information.
Audio Output: Drums
This page lets you route Drum Kit Sounds to the audio outputs.
See “Audio Output: Sty/Kbd” on page 239 for more information
about the available audio outputs.
Drum Output
This parameter lets you decide if Drum Kit Sounds will be sent
to the single output (or output pair) defined for the track they
are assigned to, or each drum category will be sent to a different
output.
Track When this option is selected, Drum Kits will be
sent to the output selected in one of the previous
pages for the tracks they are assigned to.
Drum Category
When this option is selected, you can select a dif-
ferent output for each category of Drum Kit
sounds. Use the “Drum Category” box below, to
select an output for each category of percussive
sounds.
Drum Category
Kick Bass Drum category.
Snare Snare Drum category.
Tom Tom category.
Hi-Hat Hi-Hat category.
Cymbals Cymbals category.
Perc.1 Low-pitched percussion category.
Perc.2 High-pitched percussion category.
Perc. FX Sound FX category.
Audio Output: Audio In
This page lets you connect the Audio Inputs and the Voice Pro-
cessor to the audio outputs.
See “Audio Output: Sty/Kbd” on page 239 for more information
on the available audio outputs.
Rear SW (SELECT switch)
The status of this switch, located on the rear panel, is shown by
the Rear SW diagram. From its status depends the routing of the
Audio In signal.
• When set to “MIC”, the MIC input goes to the Voice Pro-
cessor, while line inputs 1 and 2 are directly connected to
the Left and Right outputs.
• When set to “1”, line input 1 goes to the Voice Processor,
while line input 2 and the MIC input are deactivated.
Mic
The microphone input is alternative to the line input In 1,
depending on the status of the SELECT switch on the rear panel.
When selected, the signal coming from a connected microphone
goes to the Voice Processor, then is output in stereo together
with any processing made inside the Voice Processor.
In 1
The line input In 1 may be routed to the Left output, or to the
Voice Processor, depending on the status of the SELECT switch
on the rear panel.
• If the SELECT switch it is set to “MIC”, this input is sent to
the Left output.
• If the SELECT switch is set to “1”, it is sent to the Voice Pro-
cessor.
Gbl
Gbl
Gbl