Korg NAUTILUS Series, Руководство по параметрам, Страница: 410 / 961

COMBINATION mode
400
Timbre 01
X-Y Assign [Off, +X, –X, +Y, –Y]
This assigns an axis of the Vector to control the Timbre’s
volume. See the diagram “X-Y Assign and Program
Volume,” below, for more details.
Off means that the X-Y position will not affect the Timbre’s
volume.
X-Y Assign and Program Volume
Center Volume [0, 25, 50, 75, 100%]
This sets the volume of Timbre 1 at the center point. It
applies only when
Equal Amount , above, is set to Off .
The volumes at the extreme ends of the axis are fixed,
depending on the setting of the
X-Y Assign parameter.
For instance, if X-Y Assign is set to –X, the Timbre will
always be at 100% volume on the left side, and 0% (silent)
on the right side.
This parameter applies only to the Combi X-Y Volume
control, and does not change the Program’s individual X-Y
Volume settings.
Timbre Center Volume, X-Y Assign = –X
Enable Program X-Y Volume [Off, On]
When this is turned On , the Program’s X-Y Volume control
will function as it does in PROGRAM mode, crossfading
between Oscillators 1 and 2. The crossfade will be controlled
by the Program’s X-Y Envelope and is not affected by the
Combi’s X-Y Envelope.
When this is turned Off , the Program’s X-Y Volume control
will be disabled.
Volume at Show Point [%]
Shows the volume at the current X-Y point selected in
“Show Point”.
Timbres 02–16
The parameters for Timbres 2–16 are identical to those for
Timbre 01, as described above.
v 1–5: Page Menu Commands
• Compare → p.112
• Write Combination → p.433
• Exclusive Solo → p.113
• Copy From Program → p.433
• PAGE → p.126
• MODE → p.126
+127 –127 0
+X
0% 100%
+127 –127 0
–X
100% 0%
Program volume increases
from left to right. Program volume increases
from right to left.
+127
–127
0
+Y
0%
100%
+127
–127
0
–Y
100%
0%
Program volume increases
from bottom to top. Program volume increases
from top to bottom.
Volume
50%
100%
0%
X-Y X-axis position
-127 0 +127
Center Volume Values: 100
75
50
25
0