80
microX:
Ext. Control Setup
[Off, On]
This protects the external control set memory of the microX.
On (checked):
The external control set memory of the
microX will be protected, and the following writing opera-
tions will not be possible.
• Writing an external control set
• Receiving external control set data via MIDI data
dump
Off (unchecked):
External control memory sets can be writ-
ten to the microX.
■
0–2: UTILITY
☞
“Write Global Setting,” “Load Preload Data,” “Change all
bank references,” “Half Damper Calibration” (0–1)
0–3: Foot
Specify the polarity and function of a switch or pedal con-
nected to the rear panel.
0–3a: Damper/Assignable Foot Switch,
Pedal
Foot SW Assign
[Off...Tap Tempo]
Select the function that will be controlled by a pedal switch
(PS-1 option [sold separately]) connected to the rear panel
ASSIGNABLE SWITCH jack (
Foot Pedal Assign
[Off...Knob4]
Indicates the function that will be controlled by a foot vol-
ume pedal (XVP-10 or EXP-2 option [sold separately]) con-
nected to the rear panel ASSIGNABLE PEDAL jack (
Damper Polarity
[(–) KORG Standard, (+)]
Set this to match the polarity of the damper pedal connected
to the rear panel DAMPER jack.
If a Korg DS-1H (sold separately) damper pedal is con-
nected, the pedal switch polarity will be (
↓
), so select “(–)
KORG Standard
” for this setting. If you have connected a
damper pedal with a positive (
↑
) polarity, select “(+)” for
this setting. (
↓
is open-type,
↑
is closed-type.) If the polarity
does not match, operating the damper pedal will not pro-
duce the correct result. If no damper pedal is connected, set
this to “(–) KORG Standard.”
Foot Switch Polarity [(–) KORG Standard, (+)]
Set this to match the polarity of the pedal switch connected
to the rear panel ASSIGNABLE SWITCH jack.
If a Korg PS-1 (sold separately) pedal switch is connected,
the pedal switch polarity will be (
↓
), so select “(–) KORG
Standard
” for this setting. If you have connected a pedal
switch with a positive (
↑
) polarity, select “(+)” for this set-
ting. (
↓
is open-type,
↑
is closed-type.) If the polarity does
not match, operating the pedal switch will not produce the
correct result. If no pedal switch is connected, set this to “(–)
KORG Standard
.”
■
0–3: UTILITY
☞
“Write Global Setting,” “Load Preload Data,” “Change all
bank references,” “Half Damper Calibration” (0–1)
0–3a