Korenix Technology Co., Ltd.
Industrial
Layer 3 Managed Ethernet Switch
_____________________________________________________________________________
Industrial Layer 3 Managed Ethernet SwitchUser Manual
Page: 627/1568
6.25
Auto-Voice over IP Commands
This section describes the commands you use to configure Auto-Voice over IP (VoIP) commands. The
Auto-VoIP feature explicitly matches VoIP streams in Ethernet switches and provides them with a better
class-of-service than ordinary traffic. When you enable the Auto-VoIP feature on an interface, the
interface scans incoming traffic for the following call-control protocols:
Session Initiation Protocol (SIP)
H.323
Skinny Client Control Protocol (SCCP)
When a call-control protocol is detected, the switch assigns the traffic in that session to the highest CoS
queue, which is generally used for time-sensitive traffic.
6.25.1
Show Commands
6.25.1.1
show auto-voip interface
Use this command to display the VoIP Profile settings on the interface or interfaces of the switch.
Syntax
show auto-voip interface [< slot/port >]
< slot/port >
- The interface number.
Default Setting
None
Command Mode
Privileged EXEC
Display Message
AutoVoIP Mode:
The Auto VoIP mode on the interface.
Traffic Class:
The CoS Queue or Traffic Class to which all VoIP traffic is mapped to. This is not
configurable and defaults to the highest CoS queue available in the system for data traffic.
