Korenix JetNet 3205G Series, Руководство пользователя

Страница: 17 / 26

14
4. System Installation
4-1. Installation and Testing
1. Take out your JetNet 3205G series Industrial Gigabit Ethernet switch from the
package box.
2. Check if the DIN-Rail clip is attached to the JetNet 3205G series product . If the
DIN-Rail clip is not attached to the product , refer to DIN-Rail Mounting
section for DIN-Rail installation.
3. To place the JetNet 3205G series product on the DIN-Rail track or wall, refer to
the Mounting Installation section.
4. Pull the terminal blocks off the JetNet 3205G series product and wire the power
lines. Refer to 2-4 the Wiring the DC Power Inputs section for how to wire the
power inputs.
5. PWR1 and PWR2 dual power inputs can be connected to power sources
simultaneously. When the primary power source fails (the default setting is
PWR1), the system will automatically switch to the secondary power source
(PWR2), preventing any power interruption.
Both of Power 1 and Power 2 support positive electricity and negative
electricity power system. Please notice the power system for power 1 and
power 2 only accept either positive or negative electricity power system at one
time
6. Check the LEDs of PWR1 and PWR2 to make sure that JetNet 3205G series
product is operating normally.
7. Use Category 5e or Category 6 straight through Ethernet cables with RJ-45
connectors to connect network devices.
8. Connect one side of an Ethernet cable with a RJ-45 connector to the JetNet
3205G series product’s Ethernet port (RJ-45 port), and the other side of the
Ethernet cable to the network device
’s Gigabit Ethernet port.