connectors to connect network devices.
7. Connect one side of an Ethernet cable with a RJ-45 connector to the
JetNet 3008’s Ethernet port (RJ-45 port), and the other side of the
Ethernet cable to target device that equipped IP address and can
handle ICMP protocol, like as ping packet.
[Note] Make sure that the connected network switches support MDI/MDI-X function. If they
do not support this function, use a crossover Ethernet cable.
8. Check the port status LED indicator (blinking green) on the JetNet3008
to see if the network connection is established successfully.
9. Power on your host PC, make an Ethernet connection to JetNet 3008
and check the connected port is link up ;The connection diagram
shown as below:
10. To enable the “Command Line mode”, click on
Run
in the Start menu,
type
Command
, and click on
OK
to continue.
14
