Korenix JetNet 3008 v3, Руководство пользователя

Страница: 19 / 29

16
7. Connect one side of an Ethernet cable with a RJ-45 connector to the
JetNet 3008’s Ethernet port (RJ-45 port), and the other side of the
Ethernet cable to target device that equipped IP address and can
handle ICMP protocol, like as ping packet.
8. Check the port status LED indicator (blinking green) on the JetNet3008
to see if the network connection is established successfully.
9. Power on your host PC, make an Ethernet connection to JetNet 3008
and check the connected port is link up ;The connection diagram
shown as below:
10. To enable the “Command Line mode”, click on Run in the Start menu,
type Command , and click on OK to continue.
Type ping 192.168.1.1 command to check the connection. Here we use IP
[Note] Make sure that the connected network switches support MDI/MDI-X function. If they
do not support this function, use a crossover Ethernet cable.