3. Mounting Installation
3-1. DIN-Rail Mounting
The DIN-Rail clip is already attached on the rear side of JetCon 3701GP-U. JetCon
3701GP-U supports EN 50022 standard DIN Rail, in the following diagram includes
the dimension of EN 55022 DIN Rail for your reference.
The DIN rail should behind the
spring when install the JetCon
3701GP-U onto the standard DIN
Rail.
Follow the steps below to mount
the JetCon 3701GP-U to the
DIN-Rail track.
1. Insert the upper end of the
DIN-Rail clip into the back of
the DIN-Rail track from its
upper side
2. Lightly push the bottom of the
DIN-Rail clip into the track.
3. Check if the DIN-Rail clip is
tightly attached to the track.
4. To
remove
the
JetCon
3701GP-U from the track,
reverse the steps above.
