18
10
A) Stand Base For Indoor Use
1. Insert the adjusted projector to the stand base and turn
clockwise until locked.
2. Connect the 2-pin plug of the power cord to the adaptor
inlet insuring proper polarity. To avoid water getting in, make
sure to turn the plug cap clockwise until secure.
3. Connect the adapter to a approved electrical outlet.
OPERATION
1.The lamps and lanterns should be fixed to the location of the installation, and connect the wire connection to
the transformer.
2. Set this device as a projector.
3. Starting the circuit: connect the AC plug into the socket and turn a circuit on, then will light up.
4. Extract the plug if not in use. Be careful with the power cord!
ASSEMBLY INSTRUCTION
Angle
Adjustment
B) Ground Stake For Outdoor Use
1. Insert the adjusted projector to the stake and turn
clockwise until locked.
2. Connect the 2-pin plug of the power cord to the adaptor
inlet insuring proper polarity. To avoid water getting in, make
sure to turn the plug cap clockwise until secure.
3. Connect the adapter to an approved electrical outlet.
Angle
Adjustment
Ground Stake For Outdoor Use
1. Insert the adjusted projector to the
stake and turn clockwise until locked.
2. Connect the 2-pin plug
Angle
Adjustment
10
A) Stand Base For Indoor Use
1. Insert the adjusted projector to the stand base and turn
clockwise until locked.
2. Connect the 2-pin plug of the power cord to the adaptor
inlet insuring proper polarity. To avoid water getting in, make
sure to turn the plug cap clockwise until secure.
3. Connect the adapter to a approved electrical outlet.
OPERATION
1.The lamps and lanterns should be fixed to the location of the installation, and connect the wire connection to
the transformer.
2. Set this device as a projector.
3. Starting the circuit: connect the AC plug into the socket and turn a circuit on, then will light up.
4. Extract the plug if not in use. Be careful with the power cord!
ASSEMBLY INSTRUCTION
Angle
Adjustment
B) Ground Stake For Outdoor Use
1. Insert the adjusted projector to the stake and turn
clockwise until locked.
2. Connect the 2-pin plug of the power cord to the adaptor
inlet insuring proper polarity. To avoid water getting in, make
sure to turn the plug cap clockwise until secure.
3. Connect the adapter to an approved electrical outlet.
Angle
Adjustment
PROJECTION DISTANCE AND IMAGE SIZE DIAGRAM
