background image

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always be followed, including 

the following:

1. Before using, check that the voltage power corresponds to the one shown on the appliance nameplate.

2. Plug the ice maker into an exclusive grounded power outlet. No other appliance should be plugged 

into the same outlet. Be sure that the plug is fully inserted into the receptacle.

3. This appliance must be grounded. It is equipped with a power cord having a grounding plug. 

The plug must be plugged into an outlet that is properly installed and grounded. 

4. Avoid the use of an extension cord because it may overheat and cause a risk of fire. 

However, if it is necessary to use an extension cord: 

a) Use only extension cord with grounding plug. 

b) The marked rating of an extension cord must be equal to or greater than the rating of this appliance.

c) It should be positioned such that it does not drape over the counter or tabletop where it can 

be pulled on by children intentionally. 

5. Do not operate any appliance with a damage cord or plug or after the appliance malfunction or 

has been damaged in any manner. Return the appliance to the nearest authorized service facility 

for examination, repair or adjustment.

6. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or 

a similarly qualified person in order to avoid a hazard. 

7. Do not let cord hang over edge of table or counter.

8. Do not place on or near a hot gas or electric burner, or in a heated oven. 

9. Place power cord in such a way it cannot be pulled on by children or cause a tripping hazard. 

10. Place power cord in such a way that it is not in contact with hot surfaces. 

11. Do not touch the evaporator when using the ice maker to avoid being suffer from frostbite. 

12. Do not immerse any part of the product in water. 

13. To disconnect, turn any control to “OFF”, then remove plug from wall outlet. 

14. Do not plug or unplug product with wet hands. 

15. Unplug the product before cleaning,maintaining and when not in use.

16. Do not use with water that is microbiologically unsafe or of unknown quality. 

17. Do not clean your ice maker with any flammable fluids. The fumes may create a fire hazard or 

explosion. 

18. Do not overturn the ice maker. If the ice maker is overturned accidentally, make it stand steadily 

for 2 hours before power it on again.

19. If the ice maker is brought in from outside in wintertime, do not use for a few hours, allowing 

the unit to warm up to the room temperature before operating.

20. Never put flammable, explosive and corrosive articles into the ice maker.

21. Never use the ice maker when there is flammable gas leakage.

22. Never store or use gas and other flammable articles near the ice maker to avoid any fire.

23. Unplug the ice maker before moving it to avoid damaging the refrigerating system.

24. Do not attempt to disassemble, repair, modify, or replace any part of your product.

25. This appliance is not intended for used by persons (including children) with reduced physical, 

sensory or mental capabilities, or lack of experience and knowledge, unless they have been given 

supervision or instruction concerning use of the appliances by a person responsible for their safety.

26. Children should be supervised to ensure that they do not play with the appliance.

27. Close supervision is necessary when any appliance is used by or near children.

28. Do not leave the appliance unattended while in use.

29. Do not use outdoors.

30. Do not use the appliance for other than intended use.

31. Please dispose of the ice maker according to local regulators as it uses flammable blowing gas 

and refrigerant.

FEATURES

CONTROL PANEL

2

3

 

Evaporator
Ice tray

Ice shovel

Water reservoir

Control panel

Infrared 

light-emitting 

diode

Infrared

light-receiving

diode

Filter
Drain plug

"MAX" water level

Ice basket

Ice scoop

Top lid

Viewing window

Front cover

Back housing

Front housing

Compressor 

cooling fan

SELECT button

- to select “S”, “L” or “CLEAN”

  under standby mode

- to select “S” or “L” 

  when power on

CLEAN

LED indicator lights up 

when the appliance 

needs to be cleaned

ICE FULL

LED indicator lights up

when the ice basket is full.

ADD WATER

alert LED indicator

Selected ice cube size

LED light indicator

- S for small

- L for large

POWER

ON/OFF

button

POWER

LED indicator

- Standby mode: LED indicator blinks 

- Working condition: LED indicator on

Содержание KIM26-B

Страница 1: ...misuse or neglect Transportation of the unit or component from the customer to Koolatron IMPLIED WARRANTIES Any implied warranties including the implied warranty of merchantability are also limited to the duration of 90 days from the date of retail purchase WARRANTY Keep the original dated sales receipt with this manual WARRANTY AND SERVICE PROCEDURE If you have a problem with your unit or require...

Страница 2: ...crobiologically unsafe or of unknown quality 17 Do not clean your ice maker with any flammable fluids The fumes may create a fire hazard or explosion 18 Do not overturn the ice maker If the ice maker is overturned accidentally make it stand steadily for 2 hours before power it on again 19 If the ice maker is brought in from outside in wintertime do not use for a few hours allowing the unit to warm...

Страница 3: ...vaporator Over the next 7 15 minutes ice forms on the evaporator Once this has completed the ice tray will tilt backwards and the remaining water in the ice tray is drained back into the water reservoir The ice cubes are then dropped from the evaporator and pushed forward into the ice basket by the ice shovel The ice tray will automatically move back into position under the evaporator and start th...

Страница 4: ...ce making cycle 2 Clean unit 3 Send it to the authorized department for repair 1 Remove the ice from ice basket 2a Wipe up the foreign objects on the infrared light emitting diode light receiving diode and restart the ice maker 2b Call Customer Service if the infrared light emitting diode light receiving diode still can not work after wiping up the foreign objects on them and restarting the ice ma...

Отзывы: