8. Assembly, Disassembly
VRack 4U – User's Guide (prelim. version V0.99)
8.
Assembly, Disassembly
8.1.
Attaching the Rubber Feet
The rubber feet can be used for the desktop version of the system.
To attach the rubber feet to the bottom side of the chassis, please perform the following steps:
1.
Turn your system off and disconnect it from the main power supply.
2.
Make sure that all cards are secured into unit and that the system cover is installed and secured.
3.
Turn the system upside down.
4.
Remove the protective film from the self adhesive rubber feet.
5.
Attach the self adhesive rubber feet to the bottom side of the chassis.
8.2.
Cover
The cover will be fixed to the chassis using the fixing brackets at the front side of the cover (Fig. 16, pos.3), three fixing
bolts at the rear side of the cover (Fig. 16, pos.6) and the cover fastening screw (Fig. 8, pos. 12) at the front side of the
VRack 4U platform.
When closing the cover, make sure that the fixing bolts (Fig. 16, pos. 6) are inserted properly into the corresponding
retaining holes of the chassis on the rear side. The centering bracket (Fig. 16, pos. 3) and the front cover fastening screw
(Fig. 8, pos. 12) secure the cover on the front side.
6
2
1
Fig. 16: Inside of the cover with fixing brackets
1
Inside of the cover
2
Angulated centering bracket with tapped
hole (on the front side)
3
Fixing bolts (on the rear side)
www.kontron.com
23
