Chapter 9
Parallel-Port Interface
Kontron User's Guide PC/104-520
20
9.
Parallel-Port Interface
The PC/104-520 incorporates a parallel port that can be set to uni-/bidirectional and Enhanced Parallel
Port (EPP) modes.
9.1
Connector
The parallel port is available through the J8 connector (26 pins). To have the signals available on a stan-
dard, parallel interface connector DSUB-25, an adapter cable is required, which is offered by Kontron (KAB-
DSUB25-1, Part Number 96015-0000-00-0). The following table shows the pinout as well as necessary
connections for a DSUB-25 adapter.
Header
Pin
Signal Name
Function
In / Out
DSUB-25
1
/STB
Strobe
Out
1
3
PD0
Data 0
I/O
2
5
PD1
Data 1
I/O
3
7
PD2
Data 2
I/O
4
9
PD3
Data 3
I/O
5
11
PD4
Data 4
I/O
6
13
PD5
Data 5
I/O
7
15
PD6
Data 6
I/O
8
17
PD7
Data 7
I/O
9
19
/ACK
Acknowledge
In
10
21
/BUSY
Busy
In
11
23
PE
Paper out
In
12
25
/SLCT
Select out
In
13
2
/AFD
Autofeed
Out
14
4
/ERR
Error
In
15
6
/INIT
Init
Out
16
8
/SLIN
Select in
Out
17
26
NC
Not connected
--
--
10,12
GND
Signal Ground
--
18 - 25
14,16
GND
Signal Ground
--
18 - 25
18,20
GND
Signal Ground
--
18 - 25
22,24
GND
Signal Ground
--
18 - 25
Note:
1
To protect the external power lines of peripheral devices, make sure that
- the wires have the right diameter to withstand the maximum available current.
- to enclosure of the peripheral device fulfills the fire-protecting conditions of IEC/EN 60950.
To find the location of the parallel port on the PC/104-520 board, please see the Appendix “Connector Lay-
out”.