Product Description
KISS-Stor 0/5 – User’s Manual
23
RAID Level Configuration Jumper Pins
Kontron delivers the KISS-Stor 0/5 in pre-configured RAID level depending on the
ordered configuration (RAID 0 or RAID 5). The RAID level can be re-configured
manually using the RAID level configuration jumper pins located on the rear side
of the KISS-Stor 0/5.
Please do not change the pre-installed RAID level
configuration. The setting of RAID level jumper
configuration for RAID 0 and RAID 5 are included in the
manual as control information only. The changing of the
RAID-level could result in data loss.
Kontron assumes no responsibility for damage or loss
of data by using of the KISS-Stor 0/5.
To prevent the loss of data stored on a RAID array,
Kontron recommends to create a copy of your data
either on the internal HDD if available, or on an external
removable drive (CD/DVD/HDD/HDD stick).
The system must be powered down and disconnected
from the power source before attempting to change the
RAID level of the KISS-Stor 0/5.
Fig. 9: Label on the rear side of the KISS-Stor 0/5 for proper RAID 0 and RAID 5 level
configuration
RAID 0:
there are set the two jumper caps over the top pairs
of the ten RAID configuration jumper pins (refer to
R0
of the
RAID configuration label).
RAID 5:
the ten RAID configuration jumper pins are clear of
any jumper caps pins (refer to
R5
of the RAID configuration
label).
