KISS
Oil & Gas
2U User’s Manual
10.2.
Replacing the Lithium Battery
The motherboard for your system is equipped with a lithium battery. To replace the lithium battery,
proceed as follows:
1.
Open the device, as described in the
“Installing Expansion Cards” chapter.
2.
If you have added expansion cards to your system, first remove the expansion cards plus all the
corresponding connecting cables, to gain access to the lithium battery.
3.
Remove the lithium battery from the holder by pulling the ejector spring outwards.
4.
Place a new lithium battery in the battery holder.
5.
When doing this, pay attention to the polarity of the battery (the plus should be at the top).
6.
The lithium battery must only be replaced with the same type of battery or with a type of battery
recommended by Kontron America.
7.
Re-position the expansion cards and re-attach the connecting cables.
8.
Close the device, as described in the
“Installing Expansion Cards” chapter.
Fig. 34: Kontron KTQ77/Flex Motherboard with memory marked out
Do not dispose of lithium batteries in general trash collection. Dispose of the battery
according to the local regulations dealing with the disposal of these special materials, (e.g.
to the collecting points for dispose of batteries).
43
www.kontron.com