Kontron KBox A-330-RPI, Руководство пользователя

Страница: 31 / 46

KBox A-330-RPI - Draft
www.kontron.com // 31
10/ Starting Up
Before using the system, become familiar with the system components and follow the startup instructions below.
Connecting to Power Supply 10.1.
The KBox A-330-RPI connects to a DC main power supply via a Phoenix Contact input power connector on the front
panel and corresponding power cable.
When starting the KBox A-330-RPI, the functional earth connection must always be made
first and disconnected last. Kontron recommended that the last connections attached to the
system should be the power cable. Following a proper cabling procedure will prevent a false
power-on condition, which could result in an operational failure.
The KBox KBox A-330-RPI must be connected to a DC mains power supply complying with
the SELV (Safety Extra Low Voltage) requirements of EN 60950-1 standard. It must be
observed that wiring and short-circuit/overcurrent protection is performed according to the
applicable standards, regulations and respect to the electrical specification of the KBox A-
330-RPI. The disconnecting device (fuse/circuit breaker) rating must be in accordance with
the KBox A-330-RPI’s wire cross-section.
To start the KBox A-330-RPI, follow the steps below:
1.
Ensure that the DC power source is switched off via a disconnecting device (circuit breaker), in order to ensure
that no power is flowing from the external DC power source during the connection procedure.
2. Connect the power connector with wiring (refer to Chapter 9.2: Power Connector and Chapter 9.2.1: Wiring the DC
Mating Power Connector) to the Input power connector located on the front panel, see Figure 4: Front Panel (pos.
1). Pay attention to the polarity of the connections. For more information on the input power connector’s polarity,
see Chapter 12.2.1: Input Power Connector.
3.
Connect the DC power cable’s other end to the DC main power supply.
4.
Switch on the disconnecting device (circuit breaker) in order to apply voltage to the KBox A-330-RPI.
Do not disconnect the power from KBox A-330-RPI while KBox A-330-RPI is powered up!
Performing a forced shutdown can lead to loss of data or other undesirable effects!
Operating System (OS) and Drivers 10.2.
The standard KBox A-330-RPI is fully operational when switched on for the first time with pre-installed OS and
drivers. Drivers are available from Kontron’s EMD customer section.
If ordered without pre-installed OS, before starting the KBox A-330-RPI the operating system and the appropriate
drivers need to be installed for the ordered system configuration.