FlexATX-KBL-S-C236 – Rev. 1.1
www.kontron.com
// 14
7.
BIOS Setup
Enter the BIOS setup by pressing the <F2> key during boot up.
Enter “Exit Menu” and Load Setup Defaults.
To clear all BIOS settings, including Password protection, activate “Load Default BIOS
Settings” Jumper for >
10 sec (without power connected).
8.
Mounting the board in chassis
When mounting the board to chassis etc. please notice that the board contains components
on both sides of the PCB which can easily be damaged if board is handled without
reasonable care. A damaged component can result in malfunction or no function at all.
When fixing the Motherboard on a chassis it is recommended to use screws with integrated washer and a
diameter of
>
7 mm. Do not use washers with teeth, as they can damage the PCB and cause short circuits.
Recommended Power Supply for KabyLake motherboard should be above or equal to 473 W.
3.3.
Requirements IEC60950-1
Take care when designing chassis interface connectors in order to fulfil the IEC60950-1 standard.
Users of FlexATX-KBL-S must evaluate the end product to ensure compliance the requirements of the IEC60950-1
safety standard are met:
The motherboard must be installed in a suitable mechanical, electrical and fire enclosure.
The system in its enclosure must be evaluated for temperature and air flow considerations.
The motherboard must be powered by a CSA or UL approved power supply that limits the maximum input current to
10
A via 24-pin ATX connector.
For interfaces having a power pin such as external power or fan, ensure that the connectors and wires are suitably
rated. All connections from or to the product shall be with Safety Extra Low Voltage (SELV) circuits only.
Wires have suitable rating to withstand the maximum available power.
The enclosure of the peripheral device fulfills the fire protecting requirements of IEC60950-1.
