CP932
Installation
ID 30048, Rev. 01
© 2005 Kontron Modular Computers GmbH
Page 3 - 3
3004
8.01.UG.VC.050622/19130
1
P R E L I M I N A R Y
3.
Installation
The CP932 has been designed for easy installation. However, the following standard precau-
tions, installation procedures, and general information must be observed to ensure proper in-
stallation and to preclude damage to the board or injury to personnel.
3.1
Hardware Installation
The product described in this manual can be installed in any available 3U slot of a CompactPCI
system except for the system master slot.
3.1.1
Safety Requirements
The board must be securely fastened to the chassis using the two front panel retaining screws
located at the top and bottom of the board to ensure proper grounding and to avoid loosening
caused by vibration or shock.
In addition, the following electrical hazard precautions must be observed.
Caution, Electric Shock Hazard!
Ensure that the system main power is removed prior to installing or removing
this board. Ensure that there are no other external voltages or signals being
applied to this board or other boards within the system. Failure to comply with
the above could endanger your life or health and may cause damage to this
board or other system components including process-side signal conditioning
equipment.
ESD Equipment!
This Kontron board contains electrostatically sensitive devices. Please
observe the following precautions to avoid damage to your board:
Discharge your clothing before touching the assembly. Tools must be dis-
charged before use.
Do not touch any onboard components, connector pins, or board conductive
circuits.
If working at an anti-static workbench with professional discharging equip-
ment, ensure compliance with its usage when handling this product.
