Kontron CP930, Руководство пользователя

Страница: 41 / 46

CP930 Installation
ID 26683, Rev. 01 © 2003 Kontron Modular Computers GmbH Page 3 - 5
3.1.4 Installation Procedures for Use in Floppy Disk Drive Slot
To install the board proceed as follows:
1. Ensure that the safety requirements indicated above are observed (no Hotswap).
2. Ensure that the board is properly configured for operation before installing.
3. To install the board perform the following:
1. Prior to installation of the board-assembly unmount slot covers or EMC-covers of
the housing.
2. Insert the board-assembly into an appropriate slot, with the mounting holes on bot-
tom (the PCB must look up into the slot).
4. Fasten the retaining screws. Use at least 4x DIN 7985 or similar screws measuring M3x6
or M3x8
5. Connect external interfacing cables to the board as required.
6. Ensure that the interfacing cables are properly secured.
7. Close System cover according to its specific manual.
3.1.5 Removal Procedures for Use in Floppy Disk Drive Slot
To remove the board proceed as follows:
1. Ensure that the safety requirements indicated above are observed.
2. Open the system Cover.
3. Disconnect any interfacing cables that may be connected to the board.
4. Loosen all retaining screws.
5. Pull out the CP930-FDD by pulling out to the front side. (Do not use force if the assembly
is canted!)
Warning!
Failure to comply with the instruction below may cause damage to the
board or result in improper system operation.
Note...
Care must be taken when applying the procedures below to ensure that
when the board is inserted it is not damaged through contact with other
boards in the system.
Warning!
Care must be taken when applying the procedures below to ensure that
when the board is removed it is not damaged through contact with other
boards in the system.