Doc.ID: 35008, Rev 1.0
Page 3 - 3
CP6925
Installation
CUSTOMER SPECIFIC
P R E L I M A R Y
3.
Installation
The CP6925 has been designed for easy installation. However, the following standard precau-
tions, installation procedures, and general information must be observed to ensure proper in-
stallation and to preclude damage to the board, other system components, or injury to
personnel.
3.1
Safety Requirements
The following safety precautions must be observed when installing or operating the CP6925.
Kontron
assumes no responsibility for any damage resulting from failure to comply with these
requirements.
Caution!
This board is not hot swap capable, therefore it is mandatory to switch off the
CompactPCI system power before installing the board. Failure to do so could
endanger your life or health and may damage your board or system.
Note ...
Certain CompactPCI boards require bus master and/or Rear I/O capability. If
you are in doubt whether such features are required for the board you intend
to install, please check your specific board and/or system documentation to
make sure that your system is provided with an appropriate free slot in which
to insert the board.
ESD Equipment!
This CompactPCI board contains electrostatic sensitive devices. Please
observe the necessary precautions to avoid damage to your board:
• Discharge your clothing before touching the assembly. Tools must be dis-
charged before use.
• Do not touch components, connector-pins or traces.
• If working at an anti-static workbench with professional discharging
equipment, please do not omit to use it.
