www.kontron.com
CP6924-1-RA-A User Guide
14
1.2
Technical Specification
1.2.1
Power Requirements
Operating voltages are 5.0 Volt and 3.3 Volt.
The maximum power consumption is less than 50W.
1.2.2
Mechanics
Compliant to PICMG® 2.0 6U/4HP (233.35 mm x 160 mm).
•
Weight: 568g
1.2.3
Temperature
Compliant to IEC 60068-2-1 and IEC 60068-2-2.
•
Operation from -40° C to +85° C inlet air temperature
Required average inlet airflow should be around 400LFM (2 m/s) for the maximum cooling. Other thermal limitations may
apply and are the responsibility of the system integrator.
Storage temperature range is -50° C to +105° C.
1.2.4
Humidity
The boards are designed to meet the standard IEC 60068-2-78 operating 93% at 40°C (non-condensing).
1.2.5
Altitude
The boards are designed to meet the following requirements:
•
Operating: 4000m (13123 ft). Check for onboard peripherals if applicable
•
Non-Operating: 15000 m (49212 ft)
1.2.6
Vibration
The CP6924-1-RA-A board is designed to meet the requirements according EN60068-2-6:
•
10 Hz to 300 Hz, 2g acceleration
•
1 octave/min
•
10 cycles/axis, 3 directions [x, y, z]
1.2.7
Shock
The CP6924-1-RA-A board is designed to meet the VITA 47 standard:
•
Peak Acceleration: 20 g, Shock Duration: 11 ms, Recovery Time: 5 s, Shock Count: 3/direction,
6 directions
Note...
If the CP6924-1-RA-A board is used in heavy shock and vibration environment, the hole
system must withstand these requirements. This means the chassis, backplane and guid-
erails should be designed for harsh environment. Guide rails with wedge locks are recom-
mend. The backplane has to be stiffened to avoid connector micro movement. It is also
recommended to use connectors which are designed for a rugged environment.
