Kontron CP-RIO6-923, Руководство пользователя

Страница: 21 / 34

Installation
6 CP-RIO6-923 User Guide
www.kontron.com
2.2 Installation Procedure
For installing the CP-RIO6-923, it is not required that the system is powered down or the switch board in the
corresponding front slot is removed or deactivated. To install the RIO module in a system proceed as follows:
1. Ensure that the safety requirements indicated in section 2.1 are observed.
2. Carefully insert the board into the slot designated by the application requirements for the board until
it makes contact with the backplane connectors.
3. Using both ejector handles, engage the board with the backplane. When the ejector handles are locked,
the board is engaged.
4. Fasten the front panel retaining screws.
5. Connect all external interfacing cables to the board as required.
6. Ensure that the board and all required interfacing cables are properly secured.
WARNING
Failure to comply with the instruction below may cause damage to
the board or result in improper system operation.
WARNING
Care must be taken when applying the procedures below to ensure
that neither the CP-RIO6-923 nor other system boards are physically
damaged by the application of these procedures.
WARNING
DO NOT
push the board into the backplane connectors. Use the ejec-
tor handles to seat the board into the backplane connectors.