Kontron AL i.MX6 ULL, Руководство пользователя

Страница: 31 / 40

AL i.MX6 ULL - Rev. 1.0
www.kontron-electronics.de
// 31
Installation Instructions
DIN Rail Mounting
The AL i.MX6 ULL is a rail mount PC box designed for use in a DIN rail enclosure or housing by attaching a DIN rail mounting clamp.
The DIN rail mounting clamp can be attached on the rear side of the chassis.
To attach the DIN Rail mounting clamp, follow the steps below:
1. Make sure that the DIN Rail mounting clamp is in the upright position.
2. Clip the top of the DIN rail clamp into the DIN rail and push the bottom of the DIN rail firmly until it clamps on to the bottom
of the DIN rail.
Power Connector
The AL i.MX6 ULL is connected by the input power connector on the front panel to a DC power source via a DC power supply
wiring consisting of the power mating connector and the assembled wires. For information on how to wire the connector, see
Chapter 6.2.1: Wiring the DC Mating Power Connector.
Figure 10: Phoenix Power Mating Connector
1 Location for inserting the 24 V wire
2 Location for inserting the 0 V wire
6.2.1. Wiring the DC Mating Power Connector
To wire the power mating connector, follow the steps below.
1. Cut two (1 mm 2 ) AWG 18 isolated wires to the required length and strip each end 5 … 7 mm.
2. Twist the striped wire-ends and provide them with ferrules.
3. Press the contact levers of the power mating connector down - far enough so that you can insert the end of the prepared
wires.
4. Insert the wires into the corresponding clamp of the Phoenix power mating connector. Make sure that you have the right
polarity of the connection. For the pin assignment of the input power connector, refer to Chapter 3.2.1: Input Power
Connector.
The wires used for power connections must be clearly marked (+/-) to ensure proper connection to the
front panel input power connector and to the main power source. In addition, the cables must have
some form of support to minimize the strain on the unit’s connectors.
2
1