Konsberg SIMRAD RS86, Руководство пользователя

Страница: 81 / 88

Instruction Manual
81
E04819 Issue 1.0
Serial number: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Software version: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
8.5 Troubleshooting
Symptom Possible cause Remedy
Unit will not switch on • Faulty connection to power • Check power connection
• Fuse has blown • Replace fuse and check
power supply current
• Supply voltage above limit • Check supply voltage is
less than 15.6 V
Scan or Memory Scan is • Noise on the channel is holding • Increase squelch level
locking on a channel the scan • Inhibit channel from scan
without a signal (see sections 2.8.1 & 2.9.1)
Dual Watch not being • Priority channel selected • Select a working channel
entered • Handset off cradle • Replace handset
Cannot change channel • Dual Watch (D/W) engaged • Exit Dual Watch
Certain channels are • Some channels are restricted • Consult your national
not obtainable and not programmed depend- authority for permitted
ing on country of purchase channels in your region
Will not transmit • Scanning or D/W function active • Exit D/W or Scan
Will not transmit on 25W • Low voltage when full transmit- • Check power supply
but OK on 1W ting current is drawn
• Some channels are restricted to • Consult your national
low power transmission only authority
Transmissions persistently • Damaged antenna • Replace antenna
weak / display flashes • Antenna cable broken • Replace cable
ANT • Poor contact • Check antenna sockets &
through-deck connector
These simple checks should be carried out before seeking tech-
nical assistance and may save time and expense. Before con-
tacting your servicing agent, please obtain the radio’s serial
number. The software iteration should also be quoted – this is
shown in the large digits on the display for 2 seconds after the
radio is turned on and should be noted in the box below for
future reference.