WARRANTY SERVICE TERMS
12
The international manufacturer warranty is 1 year. The warranty period starts from the date of purchase.
In cases where a warranty period is longer than 1 year according to local legislation, please contact your
local dealer. The Seller of the product is responsible for granting the warranty. Please contact the Seller
for warranty. If the product fails within the warranty period because of defects in workmanship, it will be
exchanged for the same product or repaired.
The warranty card should be kept throughout the warranty period. In case of warranty card loss, a second
one will not be provided. The Customer must provide the warranty card and proof of purchase when
requesting any repair or exchange. Otherwise, the warranty service will not be provided. The warranty card
attached to the product during sale should be correctly and fully completed by the retailer and customer,
signed and stamped. In other cases, the warranty shall be deemed invalid.
Provide clean product to the service center. Parts that must be replaced are the property of the service
center.
CLEANING
CLEANING
Clean the machine after each use. Allow the motor to cool and remove the spark plug wire.
Brush off or vacuum wood chips and wipe off the remaining dust from the exterior of the machine with a
dry cloth. DO NOT rinse off the chipper/ shredder with water. Remove any chips or debris from the hopper
and the discharge chute.
It is much harder to clean the machine if you allow it to sit for a while after use. You may need to use an
engine cleaner to remove the built up resins from the motor. Engine cleaners are available at most auto
parts stores.
REPLACING BLADES FOR MODEL KS 400WS
REPLACING BLADES FOR MODEL KS 400WS
Sharpen or replace the blades as soon as the chipping performance
begins to deteriorate, or if you notice dings, chips, or cracks.
To perform this procedure:
1. Turn off the machine, allow all moving parts to come to a complete
stop, and disconnect the spark plug wire!
2. Remove the side cover plate to expose the blades. (See pic.).
3. Remove one blade, rotate the impeller, and remove the second
blade.
4. Have the original blades professionally sharpened, or order a
replacement set, then re-install the blades.
5. Replace the side cover plate and re-attach the spark plug wire.
REPLACING BLADES FOR MODELS
REPLACING BLADES FOR MODELS
KS 500WS, KS 700WS:
KS 500WS, KS 700WS:
Remove the hopper, unscrew the screws that attach the blades to
the shaft. If one side of the double bevel blade goes blunt, you can
flip the blade and use the other side which is sharp. When both
sides go blunt, order a new blade or consult a specialist to sharpen
the blade.
REPLACING V-BELT
REPLACING V-BELT
Replace or tighten the V-belt if you notice the motor running
and the chipper blades are not spinning. If an abnormal
squeaking sound is heard when you start the chopper, it is
time to replace the belt.
To perform this procedure:
1. Turn off the machine, allow all moving parts to come to a
complete stop, and disconnect the spark plug wire!
2. Remove the V-belt cover as shown in pic.
3. Roll the belt off of the pulleys and install the new belt.
4. Replace the V-belt cover and re-attach the spark plug wire.
for model KS 400WS
for models KS 500WS, KS 700WS
www.ks-power.de/en
|
11
Содержание KS 500WS
Страница 13: ......
