Operation receiver VID-TRANS300:
1) Put the camera in position
2) Connect the AC/DC adapter to the camera.
Switch on the camera with the power switch.
The power indicator lights up. Select a
channel.
3) Connect the AC/DC adapter to the receiver or
place 4x AAA batteries into the battery
compartment for power. Switch on the receiver
with the power switch. The channel indicator lights
up. Select the same channel as chosen on the
camera. The display shows the picture of the
camera.
4) Use the cursor buttons to rotate the camera horizontal and/or vertical.
5) If desired, adjust the volume and set the brightness of the picture.
6) With the AV output it’s possible to connect the
receiver to a TV/monitor or recorder with the
audio/video cable
7) Switch off the camera with the camera power button if
the system is not in use.
8) The receiver supports up to 3 cameras working at the
same time. All cameras can be seen in sequel. Press and
hold the channel button on the receiver for 2 seconds to
enable the automatic looping function. The channels are
shown one by one every 8 seconds. Press the channel
button on the receiver again to exit the looping function.
4
EN
