■
How To Transmit Audio/Video from Your Satellite Receiver
You can transmit audio/video either directly from your satellite receiver, or by
connecting them to your VCR. To transmit directly from your satellite receiver,
follow the instructions below.
1.
Connect one set of audio/video (A/V) cables (RCA or SCART cable) to the
A/V jacks of the transmitter (2283T) and to the audio/video OUT jacks (RCA
or SCART connector) of the satellite receiver or laser disc player. If you use
2283T/R, Be sure the yellow, red and white plugs match the yellow, red and
white jacks on both the satellite receiver/laser disc player and the transmitter.
2.
Plug one end of the power adapter into the back of the transmitter and the
other end into any 230-volt wall outlet (or 120-volt). Use only the adapter
provided.
3.
If your satellite receiver or laser disc player has only one set of A/V output
(RCA or SCART connector) jacks, in this case, please connect 75ohm RF
coaxial cable from satellite receiver's modulator output port to TV RF input
terminal.
4.
Locate and orient the transmitter according to the section of this manual
titled "Orienting Units for Optimum Performance" for best performance of
transmitter.
-9-
■
How To Receive Wireless Audio/Video Signals on Your TV
There are two ways to receiver wireless audio/video signals on your remote
TV (TV in another location such as in bedroom, kitchen).
•
Connect the receiver directly to the remote TV.
•
Connect the receiver to a VCR, which is then connected to the TV.
If your TV has picture-in-picture capabilities, you can view any image
transmitted by sender, such as your sleeping baby, in a small inset picture
while enjoying other programming on the rest of the screen. Consult the
owner's manual of your TV for instructions on using these capabilities.
Connecting Receiver Directly to Remote TV
If your TV has A/V jacks, connect one set of A/V cables (RCA or SCART
cable) to the TV's A/V jacks and to the A/V output jacks on the receiver
(2283R). If you use 2283T/R, Be sure the yellow, red and white plugs match
the yellow, red and white jacks on both the TV and the receiver.
If the TV has only a single jack for audio input, connect the white plug to that
jack.
-10-
TRANSMITTER
RCA TO SCART CONNECTOR A/V CABLE
TO POWER OUTLET
SATELLITE RECEIVER
950-2050 MHz CABLE
75 OHM COAXIAL CABLE
(must be purchased)
A/V IN
RF IN
SCART TO SCART CONNECTOR A/V CABLE
IN
RF
OUT
SATELLITE
IN
12VDC IN
AUDIO
LEFT
VIDEO
AUDIO
RIGHT
IR
TRANSMITTER
+
-
TEL
AC POWER
TV
RECEIVER
A/V IN
RF IN
RCA TO SCART CONNECTOR A/V CABLE
AUDIO
LEFT
+
VIDEO
-
AUDIO
RIGHT
TV
12VDC IN
