1. Equipment & Dimensions
2. Batteries/rechargeable batteries insert or change
3.a to the PLATES
3.b to K&M NOTE HEADS
3.c on TABLES
3.c and TRAYS
3. Placement of the lamp
4. Turn Light On/Off
4.a Both light heads have an ON/OFF slide switch on their
back and can be switched independently of each other
5. Adjust the Light Head
2.a
Battery case lid:
Slide the lid with your
thumb (approx. 6 mm)
in the direction of the
arrow
3.a.1
Press the clamp and slide
the music desk or other plate
(max. 25 mm)...
4.b The rotary knob on the
4.b
bracket of the base
4.b
serves as a brightness
4.b
controller (dimmer)
4.c The regulation of the
4.c
brightness is stepless in a
4.c
range between MIN (low
4.c
brightness) and MAX (highest
4.c
possible brightness)
The highly flexible goosenecks can be used to quickly place
the light in the desired position - and it will stay there until it
is adjusted again.
3.a.2
...until the plate reaches
the inside of the lower
end of the clamp
3.b.1
Press the clamp and slide
the Lyra placed in the middle
of the note head...
3.b.2
...until the plate rea-
ches the inside of the
upper end of the clamp
3.c.2
To attain optimal balance
adjust the goosenecks and
the light head a bit
3.c.1
Place the lamp
foot /base on a
level surface. Four
points of support
ensure stability
2.b
Unlock the lid
and lift
2.c
Insert three batteries (AA-1.5V)
i.e. rechargeable batteries
(AA-1.2V); (please pay
attention to the polls +/-)
2.e
Slide the lid with your
thumb over the opening
until both hooks click
into place
2.f
After the “click” ensure
that the lid is securely
in place
2.d
Place the lid on the
compartment
2 x 6
Light
diodes
Light
head (2x)
Goose-
neck (2x)
Base
Rotary knob
Dimmer
Clamp
0-25 mm
POWER UNIT
- Adapter:
In 100-240V~
50/60 Hz 0.3A
Out 5V DC-500mA
Euro plug with
-cable:
USB 2.0 type A;
cable length 2 m
DC 5V to DC 4V
barrel connector
ø 3,5 x 1,3 mm
Battery
case
(3 x AA)
Socket for
Power unit
ø max. 4.1 mm
12271 Music stand light
»Twin Head Pro«
