Technical data
Assembly
!There is a risk of crushing between the components due to the adjustment option!
Unpack and check item for damage and completeness.
Tablet PC holder
Stand
Set up and adjust the stand:
Unfold the feet of the stand until they
engage. Loosen the knurled screw on the base and pull the base tube
upwards as far as it will go. Retighten the knurled screw hand-tight.
To adjust the height, loosen the clamping sleeve and adjust to the
desired position. Retighten the clamping sleeve hand-tight.
Mounting on a stand:
When screwing on the tablet PC holder, make
sure that it does not twist. Screw the tablet PC holder hand-tight to the
used stand.
Insert and position the tablet:
Open the clamping nut on the slider and pull the slider
upwards. Place the tablet on the lower support arms.
Make sure that the back of the tablet is against the
holder, place the slider on the tablet with a little pressure
and tighten the clamping nut hand-tight. The second
hole can be used to further adjust the clamping range.
This may be necessary for smaller devices or if the
tablet is to be inserted crosswise. To do this, unscrew
the clamping nut and remove it together with the was-
her. Insert the screw into the free hole and tighten the
washer together with the clamping nut. The inclination
can be adjusted using the clamping nut on the holder.
To do this, open the clamping nut, adjust the position
and hand-tighten the clamping nut again.
Material
Base tube, extension tube, legs: powder-coated steel, black
Screws, washer, threaded bolt, rivets, clamping screw, nut:
galvanised steel
Knurled washer: anodised aluminium, black
Holder, upper joint part, lower joint part, clamping screws, knurled clam-
ping sleeve, base, parquet protector: black plastic
Load capacity
Tablets
Dimensions and
adjustment range
Height: 858-1567 mm
Root circle diameter: 660 mm
Tablet clamping range: Upper hole: 185-307 mm
Tablet clamping range:
Lower hole: 155-277 mm
Inclination: 90°
Packaging
254 x 150 x 104 mm
Weight
1.8 kg
