26735 Speaker stand
height adjustable
Setup instructions
- Lay out base plate
1
with felt pads facing down.
- Screw base tube
2
with M20 thread into base plate.
Adjusting the height
- Hold extension tube
4
with one hand.
- Using the other hand, loosen locking screw
3
and then pull spring-loaded bolt
5
(see Fig.
A
).
- Move the extension tube to the desired height.
- Snap the spring-loaded bolt
5
into the appropriate hole and retighten locking screw
3
(see Fig.
B
).
Mounting the speakers
optionally by using:
- Screw-on adapter (e.g.: 195/8, 24281) or
- Flange adapter (e.g.: 196, 19654, 19656) (available through authorized dealers)
Safety Instructions
Attention!
The max. load-bearing capacity 20 kg refers to the load capacity of the column and is adequately secured if
the points
a
,
b
,
c
,
d
,
e
,
f
,
g
are observed.
a.
Do not load the stand off-center.
b.
Make sure the screw connections are tight.
c.
Spring-loaded bolt
5
must always be snap in place.
d.
Retracting or extending the extension tube
4
:
d.
with one person: Remove the speaker from the extension tube first
d.
with two persons: Speaker can remain on the extension tube if the first (suitable) person holds the
d.
loaded extension tube firmly and securely and the second person operates the locking screw and
d.
the spring-loaded bolt.
e.
Uncontrolled loosening of the locking screw and the spring-loaded bolt under load is not permitted.
f.
Stand only suitable for even ground.
g.
For indoor use only.
Tipping hazard
by unauthorized external influences on the stand, e.g. shocks from public traffic, wind, vibrations, etc.
must be counteracted by suitable measures:
h.
Keep a safe distance, keep unauthorized persons away, select protected installation locations.
If the effectiveness of the measures a - h cannot be guaranteed (e.g. due to uncontrollable non-compliance
with the safety distance), additional safety measures must be taken by the installer:
i.
Anchoring of the base plate at the floor.
k.
Suitable extension of the base plate.
Please note additionally
- Handle base plate
1
with care, especially do not drop it during installation.
1
2
3
3
4
5
5
KÖNIG & MEYER
GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
26735-000-55/76 Rev.29/Rev.15 03-80-831-00 12/20
min. 1
100/max. 1810 mm
Screw-on adapter
e.g. 195/8
Flange adapter
e.g. 19656
