INSTALLATION (A-I)
19776 Tablet PC stand
- Equally suitable for the stage, home and studio
- For tablet PCs with width 160-320 mm, height 120-222 mm
-The stand holder is an effective and secure attachment system for tablet PCs:
-
guaranteed by the integrated spanning tension spring and the side guard arm (3)
- A secure hold is provided by the integrated moss rubber protectors on the spanning
-
clamping jaws, vibration sound is eliminated and the tablet housing protected
- Adjustment options to fulfil every requirement:
-
tablet size, tilt angle, direction, portrait/landscape format
- Stand can be adjusted to any height between 700 and 1550 mm
SAFETY NOTES
- Please place the tablet PC in the cradle carefully and check for secure fit
- Manoeuvre the stand holder with care; e.g. when changing the setting (tilt, format and direction)
- The Bottom must be suited, i.e. level underground with carrying capacity is a requirement
- Always hand-tighten clamp screws
- Protection from wind, rain, impact, etc.
Thank you for choosing this product. These instructions contain information about the installation
and use of the tablet PC holder. We suggest you keep the instructions in a safe place for later use.
A
PREPARE THE STAND
A
a. Fold feet apart
A
b. Loosen base screw and move base down to the stop;
A
b.
tight base screw again
A
c. Loosen clamps, adjust extensions to the desird height
A
c.
and tighten clamps again
B
LAY OUT THE COMPONENTS FOR 19776 IN ORDER
B
1
Tablet cradle
B
2
Swivel joint
B
3
Guard arm
C
PRE-ADJUSTING THE TABLET CRADLE
C
4
Ensure that the "large latch" is disengaged -
C
4
look for the 3 mm gap (see Fig.)
C
4
Slide the "large latch" upwards, applying gentle
C
4
strength. There will be an audible click.
C
5
Slide out the upper section:
C
5
The distance between the sides should be
C
5
approx.10-15 mm less than the height or width
C
5
of the tablet PC.
C
6
Slide the "large latch" back down (there should
C
6
be an audible click)
D
CONNECTING THE SWIVEL JOINT TO THE MICROPHONE STAND
D 1
7
First, turn the knurled disc on the screw mounting of the stand as
D 1 7
far as it will go
D 1
8
Swivel joint - also turn this on the screw mounting
D 1 8
– but not as far as it will go – we recommend leaving a
D 1 8
gap of approx. 3 turns
D 1
9
Turn the knurled disc in the opposite direction until there
D 1 9
is no more free play between it and the swivel joint
D
10
Tighten the wing nut
E
ATTACHING THE GUARD ARM
E
11
Place the guard arm in a suitable groove of the
E 11
swivel joint in such a way that the end sits closely
E 11
with the tablet (
11a
)
E
12
Important:
E 12
The tablet PC must be aligned centrally
E 12
(see points
26
and
27
), if necessary, correct the
E 12
position of the guard arm.
T
ablet PC
