KÖNIG & MEYER
GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
19752-000-55 Rev.11 03-80-143-00 7/12
TECHNICAL DATA
Material
swivel joint, holder-plate : Polyamid (PA-6)
stand, screws: steel, black powder coated
screwing: steel, zinc coated
Max. load
iPad 2. Generation (630 g), iPad 3. Generation (670 g)
Size
base dimensions : 252.1 x 145 x 286 mm
Weight
net 1.28 kg, gross 1.48 kg
USERS TIPPS / DIMENSIONS
MOUNTING INSTRUCTIONS
19752 iPad Table Stand
- Strength and stability! A clever way to show off your iPad.
- The new mount guarantees to hold the iPad effectively and safely.
- The iPad is clipped in and out of the holder effortlessly.
- An easy-to-use wing nut adjusts the tilt so the user can easily find a position to suit them.
- The iPad can rapidly switched between the vertical an horizontal format, whereby slip is prevented.
SAFETY INSTRUCTIONS
Thank you for choosing this product. This instruction manual informs you about the important steps to set
up an handle the product. We recommend to keep the manual in a separate place for a possible later use.
(FF) FAULT FINDING & (R) REPAIR
FF: holder wobbles
FF:
R: Tighten wing nut
3
FF: iPad wobbles
FF:
R: Lock in place iPad correctly
1
- let´s hear the "click" noise
2
FF:
R: Note the correct position of the iPad
7.a
,
7.b
FF:
R: ATTENTION! Not suitable for iPad 1. Generation.
SETTINGS - Tilting & Format (vertical/horizontal)
The iPad can remain in position.
TILTING
Choose any angle between 0-90°.
3
Hold the iPad and loosen wing nut
4
Tilt iPad into desired angle and
5
Tighten wing nut again
FORMAT
The iPad can be rapidly switched between
the vertical and horizontal format.
6
turn holder-plate into desired format
6
- or into slant !
6
Invisible mechanical stops limits the adjustment
TIPP
Beware of the position of the on/off-switch
7.a
- at the bottom
7.b
- on the right side.
Effect: due to the mechanical stop inside of the holder
the cord of a head phone set couldn´t cause a rotation.
will cause a turning traction to the iPad.
A.
The iPad table stand is ready for use.
B.
When attaching the iPad the ON/OFF-switch
B.1
B.
should pe located below or on the right side.
B.
That´s the way to ensure accessible connectors.
B.
For more informations see:
7.a
,
7.b
.
1
place iPad into the holder-plate and
2
clip in the iPad at last
For removal please notice reverse order.
- Suitable for
iPad 2. or 3. Generation
,
-
not suitable for iPad 1. Generation
- Use only on even surfaces
- Clip in the iPad carefully and check the correct positioning
- Handle with care, particularly while changing the setting
-
(tilting, vertical/horizontal format)
