KÖNIG & MEYER
GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
15915-000-55 Rev.02 03-80-319-00 01/15
TECHNICAL DATA
SETUP INSTRUCTIONS
15915 Mute holder
- to expand Mute Holder 15910
-
and fits perfectly
- Mute holder is rubberized
SAFETY NOTES
Thank you for choosing this product. The instructions provide directions
to all of the important set up and handling steps. We recommend you
keep these instructions for future reference.
Disassemble mute holder 15910
1
Completely remove the wing nut and remove
1
the discs and holder rings.
1.a
If a new mute ring is replacing an old one the
1.a
carriage bolt remains (M6 x 35 mm)
1.b
Should the new mute ring be used in addition to the other
1.b
mute rings, the carriage bolt (M6 x 35 mm)
1.a
is removed
1.b
and replaced with a longer screw (M6 x 45 mm).
Use mute holder 15915
2
Use the mute holder as illustrated:
2
- the order of the rings can be set as desired
2
- a plastic disk is to be placed between the rings
3
plastic disc (ø 20 x 5 mm)
4
The wing nuts are to be placed on the carriage bolt
4
and tightened.
ATTACHING the holder to the stand
5
The clamp prisma is equipped for tubes up to 30 mm.
5
The prismatic clamp is threaded through the tube and
5
is attached by tightening the finger screw..
ADJUSTMENT of the mute holders
6
Loosen the wing nuts a bit.
7
Place the mute rings in the desired position
7
and tighten the wing nuts
6
.
OPTIONS
7.a
wide distances - easy access - attractive appearance
7.b
placement as close to the stand as possible is
7.b
recommended for light stands for safety reasons
7.c
complete with 4 mute holders
PLACEMENT of the mutes
8
Place the mute in the ring that fits best
8
(see measurements)
8
ø 95, 80, 80 und 60 mm.
- Please check the stands in regard to their
-
load bearing weight and sturdiness.
- The fact that the product is collapsible and adjustable requires
-
careful and attentive handling during setup,
-
operation, and disassembly.
- Only to be used for mutes; other products are not permitted.
- Damaged parts may not be used
-
and are to be replaced.
Material
Support arms: Steel, powder
coating, black
Screws: Steel, galvanized
Handles, caps: Plastic (PA)
Rubberized: Plastic (TPE)
Load
Mutes
Dimensions
Ring inside: ø 95 mm
Weight
0.1 kg
Packaging
PE-Bag 200 x 270 mm
MOUNTING
OPTIONS
ORIENTATION
PACKAGE DIMENSIONS
for appearances
and easy accessibility
distribute evenly
for
sturdiness
place as close
to the stand
tube as possible
for
multiple instruments:
with four mute holders
(ø 95, 80, 80, 60 mm)
The holder is collapsible
for easy transport
Included in the
delivery 15915
