für die
Multiinstrumentalisten:
mit viertem Aufnahmering
(Best-Nr. 15915, ø 95 mm)
KÖNIG & MEYER
GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
15910-000-55 Rev.04 03-80-318-00 01/15
TECHNICAL DATA
SETUP INSTRUCTIONS
15910 Mute holder
High quality and flexible
- holds up to 3 mutes for trumpets, cornets and Flugelhorns
- mute holders are rubberized
- flexible and easy to adjust and operate
- attaches to stands with diameters of up to 30 mm
- the holder collapses, has a small footprint and is easy to transport
SAFETY NOTES
Thank you for choosing this product. The instructions provide directions
to all of the important set up and handling steps. We recommend you
keep these instructions for future reference.
MAINTENANCE
To care for the product use a damp cloth
and a non-abrasive cleaning agent.
FAULT-FINDING (F) and REPAIR (R)
F: Installation looks like its tilting
F.
R: Tighten the clamp
F: The stand is lilting to one side
F.
R: Check to ensure that the stand is suitable for the load
F.
R: Balance the loads on the stand (see
3.b
)
Assemble the holder
The product comes completely pre-assembled.
ATTACHING the holder to the stand
1
The clamp prisma is equipped for tubes up to 30mm.
1
The prismatic clamp is threaded through the tube and
1
is attached by tightening the finger screw.
ADJUSTMENT of the mute holders
2
Loosen the wing nuts a bit.
3
Place the mute rings in the desired position
3
and tighten the wing nuts
2
.
OPTIONS
3.a
wide distances - easy access - attractive appearance
3.b
placement as close to the stand as possible is
3.b
recommended for light stands for safety reasons
3.c
additional Mute Holder 15915 - for a fourth mute
PLACEMENT of the mutes
4
Place the mute in the ring that fits best
4
(see measurements)
- Please check the stands in regard to their load bearing
-
weight and sturdiness.
- The fact that the product is collapsible and adjustable
-
requires careful and attentive handling during setup,
-
operation, and disassembly.
- Only to be used for mutes; other products are not
-
permitted.
- Damaged parts may not be used and are to be replaced.
Material
Prismatic clamp, bracket, support arm:
Steel, powder coating, black
Screws: Steel, galvanized
Handles, caps: Plastic (PA)
Rubberized: Plastic (TPE)
Load
Mutes
Dimensions
Rings: 2 x ø 80 mm, 1 x ø 60 mm
Prisma: ø 7-30 mm
Collapsed Size: 92 x 100 x 178 mm
Weight
0.3 kg
Packaging
PE-Bag 200 x 270 mm
Accessories
Forth Ring ø 95 mm, Order No. 15915
MOUNTING
OPTIONS
ORIENTATION
PLACEMENT & DIMENSIONS
PACKAGE DIMENSIONS
For
appearances
distribute
evenly
for
sturdiness
place as close
to the stand
tube as possible
The holder is collapsible
for easy transport
HOLDER RING
Order No. 15915
