E-4
13. Attach supplied 14 wire saddles (medium), one
wire saddle (large), and two edge covers.
Note:
Attach the wire saddle (large) to the hole marked
with “8.”
14. Route the harness of the heater through the
three wire saddles and edge cover.
* For information on the following steps, refer to the
installation manual of the power supply Box MK-
734.
<When the paper feed cabinet/Desk is not
installed in the main unit>
Note:
If protective tape or protective materials are
attached to the paper feed cabinet/Desk, refer to
the installation manual of each option and remove
them in advance.
1. Pull out the tray from the paper feed cabinet/
Desk.
Note:
For the paper feed cabinet PC-110/210, pull out
the upper tray.
2. Remove the rear cover from the paper feed cabi-
net/Desk. (Five screws)
Note:
If the extender harnesses are taped, remove the
tape.
A4NHIXE026DA
Wire saddle (large)
A4NHIXE027DA
A4NHIXC015DA
A4NHIXE016DA
Extender harness
