FS-501
– 4 –
■
Installing the Accessories
1. Peel off the seal covering the area where the
stabilizing pin and magnet plate will be
attached.
4583U016AA
2. Attach the enclosed stabilizing pin and
magnet plate with the enclosed screws A to
the left side of the machine as shown.
C4683U009AA
3. Place the Ground Plate furnished with the kit
in Rail Guide B.
4684U063AB
4. Attach the rail guide B to the left side of the
Paper Feed Unit as shown in the illustration
(two screws B furnished with the finisher).
NOTE
Fit Rail Guide B in the tab on the lower
portion of the Paper Feed Unit.
4684U064AA
5. Insert the rail into the Rail Guide B.
6. Protrude the leading edge of the rail out
about 60 mm to the right from the right end of
the machine.
NOTE
If the rail is pulled out more than necessary,
it is caught by the flat spring fitted to the
machine as it is brought back into the
original position.
7. Insert the spacer that comes with the finisher
into the rail.
NOTE
Slide out the rail to the left and check that it
does not come off the Rail Guide B.
4684U065AA
4583U017AB
8. Slide the other end of the rail installed in step
5 into the rail guide on the finisher.
NOTE
Insert the rail until it snaps into place.
At this time, the finisher should stay
attached to the machine, even if you try to
pull it away.
C4683U010AA
C4683U011AA
