E-4
15. Install the local interface board unit. Put the
dowel into the hole and fix the unit with one
screw.
Note:
• Be sure to put the hook on the local interface
board unit into the positioning hole on the main
body.
• If loosened cables prevent the installation of the
local interface board unit, adjust the slack on
the cables from the gap created when the IR
upper front cover is removed in step 2.
16. To install the covers and other parts removed in
steps 2 to 4, reverse the removal procedure.
III. Affixing the label
Affix the label furnished with the local interface kit to
the position shown below.
IV. Setting the bluetooth
<EK-605 only>
1. Plug the power cord into the power outlet and
turn on the machine.
2. Display the Service Mode screen.
(For details of how to display the Service Mode
screen, see the service manual.)
3. System 2
→
→
Bluetooth Settings
4. Touch “Effective.”
5. Touch “END.”
6. Touch “Exit” on the Service Mode screen.
7. Turn OFF and ON the Main Power Switch.
Note:
When displayed the Service Mode screen, be sure
to turn off the main power after exiting the Service
Mode screen and wait for 10 seconds or more
before turning on.
8. Press [Utility/Counter].
9. Touch “Administrator Settings.”
10. Enter the administrator password and then press
“OK.”
11. Network Settings
→
Forward
→
Bluetooth Set-
ting
12. Check that “Enable” is selected and touch “OK.”
13. Touch “Close.”
14. System Connection
→
Cellular Phone/PDF Set-
ting
15. Check that “Allow” is selected and touch “OK.”
16. Continue to touch “Close” until the initial screen
appears.
A0YCIXC016DA
Hook on the unit
Dowel
A0YCIXC017DB
Label
